High Performance Refuse Collection Vehicle

Python Lift 9-foot reach. Capable of below level grade pickup. 1,250 lbs. lift capacity @ 2-6 feet, 625 lbs. at full reach. 6-8 second cycle time. Air over hydraulic joystick controls standard The standard AutoLoad system uses only the joystick and 2 buttons to reach, grab, lift, dump, and return the arm to the stowed position. No electronic controls or devices required Operate-in-gear-at-idle Smooth action directly to hopper. Lids close when carts replaced. John Deere Cylinders Available in 24 cubic yard body capacity 5.2 cubic yard front hopper capacity. Compaction of up to 1,000 lbs per cubic yard. Premium Components Grabber gears housed in oil bath gearbox. Gears made from specially formulated high strength, low alloy steel. Gears shown are after 1,000,000 cycles with no evidence of wear Gears are splined to grabber shafts 3-inch progressive cushions on reach, lift, and grab cylinders. Formula 5000 Tailgate Over 16,000 built Chrome plated and induction hardened cylinders High pressure hydraulics Linkage packing system with no slides or rollers to wear out Manual packing controls allow operator to stop, start, or reverse either upper panel or blade at any point in the packing cycle. Cycle is completed in two steps, one hand operation. Reload in 9 to 11 seconds. Rear loader hopper volume of 3.94 cubic yards. Can be equipped with commercial container handling devices. DuraPack Family Body Fully welded interlaced subframe. Body sides made from single sheet of steel. Concealed and protected hydraulic tubes. All high tensile steel construction. Body components welded by state-of-the-art robotics.